| 伸缩门气候冷下来就出现问题一般就有三种情况 |
| 添加时间：2019/12/31 9:47:09 浏览次数： |
| 如果伸缩门在天气暖和时正常使用，气候冷下来就出现问题的，一般就有三种情况： If the expansion door is used normally in warm weather and the climate is cold, there are generally three situations: 1、早晚起动不了或全天候起动需要借助外力： 1. It can't be started in the morning or in the evening or it needs to be started in all-weather with the help of external force: <1> 早晚启动不了，建议先让电机在零负荷的力度时空转一会（打开离合空转）； <1> If it can't be started sooner or later, it is suggested to let the motor run for a while at zero load force (open clutch idling); <2> 如果伸缩门已使用过有一段时间的、在电机变速箱加点防寒润滑油； <2> If the expansion door has been used for a period of time, add cold proof lubricating oil to the motor gearbox; <3> 可加大电机起动功率（加大相应电容）。 <3> Increase the starting power of the motor (increase the corresponding capacitance). 2、走偏： 2. Deviation: <1> 加强控制器纠偏力度。纠偏设置，在停机状态，调整线路板上纠偏幅度拨码开 Strengthen the rectification of the controller. Set the deviation correction, adjust the deviation correction amplitude on the circuit board and dial the code to open in the shutdown state 关，1.2开关都拨至下方位置纠偏幅度为中，1.2开关任意一个拨上至ON位置纠 Turn off the 1.2 switch to the lower position, and the deviation correction amplitude is medium. Turn any 1.2 switch to the on position for correction 偏幅度为强，1.2开关都拨上至ON位置纠偏幅度为标准。纠偏幅度共设为标 The deviation amplitude is strong, and 1.2 switch is set to on position, and the deviation correction amplitude is the standard. Deviation correction range is set as the standard 准、中、强三档。请根据实际情况选择档位。出厂设置为标准档。 Accurate, medium and strong. Please select the gear according to the actual situation. Factory set to standard. <2> 加重机头，增加机头轮着地力度，让伸缩门走得更平稳； <2> Increase the weight of the head, increase the landing force of the head wheel, and make the expansion door go more smoothly; <3> 转动链条的松紧调测，务必做到平衡； <3> Adjust the tightness of the rotating chain to make sure it is balanced; <4> 针对门排机头固定螺丝进行一个加固，不能出现有任何一个连接件或机头机电 <4> One reinforcement shall be made for the fixing screw of the head of the door truss, and there shall be no connection or mechanical and electrical parts of the head 固定件的松动。 Loose fixings. 3、防撞干扰易出故障： 3. Anti collision interference is prone to failure: <1> 冷天防撞发射头镜片上有雾水，或有冰都会造成干扰，应及时清理； <1> If there is fog or ice on the lens of the anti-collision transmitter in cold weather, it will cause interference, so it should be cleaned in time; <2> 在相应时期暂停红外的使用。 <2> Suspend the use of infrared in the corresponding period. |
| 上一页 不锈钢电动伸缩门主体结构特点 |
| 下一页 门禁系统安装施工布线过程中，哪些方面需要注意 |
Copyright © 技术支持：遨游网络