沧州电动门厂

一问:询问客户机型、品名、损坏原因、故障现象。主要内容有：何时损坏，是否浸水，是否受过撞击，是否电压过高，是否有人改动，是否操作不当，是否遭受雷击，是否有冒烟现象，是否有异常响声等。对于雷击、浸水、冒烟、烧保险等故障机型,切不可贸然通电试机,否则将造成机器再次受创、故障扩大。

Question: ask customer type, name, damage reason, fault phenomenon. The main contents are as follows: when the damage is submerged, or an impact, whether the voltage is too high, if someone changes, if improper operation, whether the lightning, whether there is smoke phenomenon, whether there is abnormal sound. For lightning stroke, immersion, smoke, burning insurance and other fault models, we must not rush the electric test machine, otherwise it will cause the machine to be damaged again and fail to expand.

二看：即观察,打开伸缩门控制外壳后,应仔细查看电路板上是否有元件受损。如元件断裂、发黑发黄、引脚相碰、器件松动、连线错误等。有经验的维修人员会根据用户提供的相关信息及故障现象,准确地察看伸缩门可疑部位,麻利地找出故障所在。某些接触不良的故障,可在光线较暗处观察可疑部件是否有火花产生来确定(注：某些接触不良故障,尤其是在电源通电后,因故障点接触不良而产生火花)。

Two see: that is to observe, open the telescopic door control shell, should carefully check the circuit board whether there are components damaged. If the component fault, black hair yellow, touching, pin loosening, device connection error etc.. Experienced maintenance personnel according to the relevant information and provide users with accurate fault phenomenon, to inspect the telescopic door suspicious position, quickly find a fault. Some faults of bad contact, whether in the light is dark to observe suspicious spark components to determine (Note: some bad contact failure, especially in the power supply of electricity, poor contact due to failure to produce sparks).

三听：即听声,在控制系统中,大都采用了电磁继电器作为控制器件,在继电器触点切换时会产生清晰的“滴哒”声。如无声或异常,在确定继电器驱动电器无故障后,可判定该继电器不良。

Three listen: listen to the sound, in the control system, is widely used in electromagnetic relay as the control device, the relay switching will produce a clear "tick" sound. If silent or abnormal, the relay can be judged bad after determining the fault of the relay drive electric appliance.

四摸：即触摸,在伸缩门的维修过程中,也经常在通电后用手摸(鼻嗅)某些元件。如稳压IC等集成器件、防雷管、变压器、驱动二极管等等,以便感觉其温度是否正常,如发热快、温度高、电路无短路故障则可断定器件不良(注意：对于高电压的元件如可控硅、高压区的元器件,应通电一段时间再断电后迅速触摸,切勿通电时触摸,避免触电事故)。

Four touch: touch, in the maintenance process of retractable door, also often touch the hand (nose, smell) some components after the power. If the regulator IC integrated devices and lightning protection tube, transformer, diode driving and so on, to feel the temperature is normal, such as fast heating, high temperature, short circuit fault can be concluded that bad devices (Note: for high voltage components such as SCR, high pressure area components, power should be a period of time do not touch the power quickly, energized touch, avoid electric shock accidents).