联系我们
公司名称：XXX
电话：XXX
手机：XXX
联系人：XXX
地址：XXX
新闻动态
门禁系统安装施工布线过程中，哪些方面需要注意
1、所有走线都必须套管， PVC管和镀锌管都可以，避免老鼠咬断线路引起故障。强烈建议：本系统的所有走线必须同220V强电线分开套管；
1. All wiring must be sleeved, PVC pipe and galvanized pipe can be used to avoid the fault caused by mouse biting off the line. It is strongly recommended that all wires of the system should be separated from the 220 V strong wires by sleeves;
2、虽然控制器具备了良好的防静电、防雷击、防漏电设计，请务必保证控制器机箱和交流电地线连接完善，且交流电地线真实接地；
2. Although the controller has good anti-static, anti lightning and anti leakage design, please make sure that the controller case and the AC ground wire are well connected, and the AC ground wire is truly grounded;
3、建议您不要经常带电拔插接线端子，请务必拔下接线端子，再进行相应的焊接工作；
3. It is recommended that you do not always plug and unplug the terminal blocks with electricity, and then do the corresponding welding work;
4、请勿擅自拆卸或者更换控制器的芯片，非专业的操作会导致控制器损毁；
4. Do not disassemble or replace the chip of the controller without authorization, and unprofessional operation may cause damage to the controller;
5、不建议您擅自对接其他附加设备，所有非常规的操作，请务必先于我方工程师沟通；
5. It is not recommended that you connect other additional equipment without permission. All unconventional operations must be communicated before our engineers;
6、用电方面，不要将控制器和其他大电流设备接在同一供电插座上；
6. In terms of power consumption, do not connect the controller and other high current equipment to the same power supply socket;
7、读卡器、按钮的安装高度距地面1.4米，可以根据客户的使用习惯，适当增加或者降低；
7. The installation height of card reader and button is 1.4m away from the ground, which can be increased or decreased appropriately according to customers' usage habits;
8、控制器建议安装在门内侧的天花板上或弱电井等便于维护的地点；
8. The controller is recommended to be installed on the ceiling inside the door or weak current well and other places convenient for maintenance;
9、接线端子注意规范接线，不要裸露金属部分过长，以免引起短路和通讯故障；
9. Pay attention to the standard wiring of wiring terminal, do not expose the metal part too long, so as to avoid short circuit and communication failure;
10、线与线的连接，最好使用电烙铁焊接，拧接方式容易造成接触不良。
10. Wire to wire connection, the best use of electric soldering iron welding, screw connection is easy to cause poor contact.
1. All wiring must be sleeved, PVC pipe and galvanized pipe can be used to avoid the fault caused by mouse biting off the line. It is strongly recommended that all wires of the system should be separated from the 220 V strong wires by sleeves;
2、虽然控制器具备了良好的防静电、防雷击、防漏电设计，请务必保证控制器机箱和交流电地线连接完善，且交流电地线真实接地；
2. Although the controller has good anti-static, anti lightning and anti leakage design, please make sure that the controller case and the AC ground wire are well connected, and the AC ground wire is truly grounded;
3、建议您不要经常带电拔插接线端子，请务必拔下接线端子，再进行相应的焊接工作；
3. It is recommended that you do not always plug and unplug the terminal blocks with electricity, and then do the corresponding welding work;
4、请勿擅自拆卸或者更换控制器的芯片，非专业的操作会导致控制器损毁；
4. Do not disassemble or replace the chip of the controller without authorization, and unprofessional operation may cause damage to the controller;
5、不建议您擅自对接其他附加设备，所有非常规的操作，请务必先于我方工程师沟通；
5. It is not recommended that you connect other additional equipment without permission. All unconventional operations must be communicated before our engineers;
6、用电方面，不要将控制器和其他大电流设备接在同一供电插座上；
6. In terms of power consumption, do not connect the controller and other high current equipment to the same power supply socket;
7、读卡器、按钮的安装高度距地面1.4米，可以根据客户的使用习惯，适当增加或者降低；
7. The installation height of card reader and button is 1.4m away from the ground, which can be increased or decreased appropriately according to customers' usage habits;
8、控制器建议安装在门内侧的天花板上或弱电井等便于维护的地点；
8. The controller is recommended to be installed on the ceiling inside the door or weak current well and other places convenient for maintenance;
9、接线端子注意规范接线，不要裸露金属部分过长，以免引起短路和通讯故障；
9. Pay attention to the standard wiring of wiring terminal, do not expose the metal part too long, so as to avoid short circuit and communication failure;
10、线与线的连接，最好使用电烙铁焊接，拧接方式容易造成接触不良。
10. Wire to wire connection, the best use of electric soldering iron welding, screw connection is easy to cause poor contact.
